Specialized Tool

Retatrutide Dosage Calculator

Retatrutide is a triple agonist (GLP-1 / GIP / glucagon) typically dosed once weekly. Enter your vial size, the bacteriostatic water you'll add, and your target weekly dose — the visual syringe below shows exactly where to pull the plunger.

= 2,000 mcg | Starting point: 2mg once weekly (half the recommended initial dose). Titrate up only as tolerated.

1 mg = 1,000 mcg (micrograms). Most peptide protocols are written in mcg.

mg

Common vial sizes for Retatrutide are 10 mg and 20 mg.

mL
Syringe size
Draw to
40 units
00.0100.1200.2300.3400.4500.5600.6700.7800.8900.91001.0DRAW TO 40u100-UNIT · 1 mL SYRINGE40u
Concentration
5.00 mg/mL
Volume / dose
0.400 mL
Doses / vial
5
Dose
2.00 mg
Step by step

Reconstitution steps

Every step below uses the numbers you entered above.

  1. 1
    Wipe both stoppers

    Swab the rubber tops of the 10 mg Retatrutide vial and the bacteriostatic water vial with fresh alcohol pads. Let them air dry for a few seconds.

  2. 2
    Draw 2 mL of BAC water

    Pull 2 mL of bacteriostatic water into a reconstitution syringe (usually a 3 mL syringe with a 21g needle).

  3. 3
    Add water slowly, down the side

    Inject the water against the inside wall of the vial, don't blast it directly onto the powder. This protects the peptide from shear damage.

  4. 4
    Swirl, don't shake

    Gently swirl until the powder is fully dissolved and the liquid is clear. Never shake, foaming denatures the peptide.

  5. 5
    Draw 40 units on a 1 mL syringe

    On your 100-unit (1 mL) insulin syringe, pull the plunger back until the rubber tip lines up with 40, that's your 2.00 mg dose. Tap out any air bubbles, then inject as directed.

  6. 6
    Store refrigerated

    Cap the vial and store at 2–8 °C (36–46 °F). Most reconstituted peptides remain stable for 3–4 weeks refrigerated.

About Retatrutide dosing

Retatrutide is a once weekly investigational triple agonist. This calculator defaults to 2mg/week, a conservative initial dose that is half the typical recommended starting dose. Titrate up only every 4 weeks and only as tolerated. Reconstitute the lyophilized powder with bacteriostatic water, tilt gently — never shake — and store the reconstituted vial refrigerated.

The math above mirrors what's on the Retatrutide product page at Branch Peptides, just with a specialized calculator built around weekly GLP-1-class dosing.

Where to get it

AnyPeptides doesn't sell peptides — we send you to Branch Peptides, our trusted research grade source. Use code ANYPEPTIDES15 for 15% off your first order.

Discount may end or change without notice.

View Retatrutide at Branch Peptides →

Retatrutide dose to units chart

For a 10 mg vial mixed with 2 mL bacteriostatic water (5.00 mg/mL), on a U-100 insulin syringe.

DoseVolumeUnitsDoses per vial
1 mg0.200 mL20u10
2 mg0.400 mL40u5
4 mg0.800 mL80u2
6 mg1.200 mL120u1
8 mg1.600 mL160u1
12 mg2.400 mL240u0

Retatrutide titration schedule

Units shown for your current vial and water amount (10 mg / 2 mL).

WeeksWeekly doseUnits to draw
1 to 42 mg40u
5 to 84 mg80u
9 to 126 mg120u
13 to 168 mg160u
17+12 mg240u

Step up only when the current dose is well tolerated. Many people stay at a lower dose for longer.

Frequently asked questions

How many units is 2 mg of Retatrutide?

With a 10 mg vial and 2 mL of bacteriostatic water (5 mg/mL), 2 mg is 0.4 mL, which is 40 units on a U-100 insulin syringe.

How much BAC water do I add to a 10 mg Retatrutide vial?

Common choices are 1, 2 or 3 mL. 2 mL gives 5 mg/mL, so every 10 units equals 1 mg.

What is the Retatrutide titration schedule?

Many protocols start at 2 mg once weekly for 4 weeks, then step up every 4 weeks (4, 6, 8 and up to 12 mg) only as tolerated.

How many units is 4 mg of Retatrutide?

At 5 mg/mL (10 mg vial + 2 mL water), 4 mg is 0.8 mL, which is 80 units.

Retatrutide vs Tirzepatide vs Semaglutide?

Semaglutide targets GLP-1 only. Tirzepatide adds GIP. Retatrutide is a triple agonist (GLP-1, GIP, glucagon) with the strongest weight loss signal in trials so far.

When do you inject Retatrutide?

Once weekly, same day each week, under the skin of the abdomen, thigh or upper arm.

Trusted source
Buy Retatrutide at Branch Peptides

Use code ANYPEPTIDES15 for 15% off your order.

Discount may end or change without notice.

Shop on BranchPeptides.com

Keep exploring

Related tools and guides across the site.

Language