Healing

GLOW Blend

Skin, hair & systemic healing blend (GHK-Cu 50mg / BPC-157 10mg / TB-500 10mg)

The 'lit from within' stack — collagen, repair, and capillary tone in one shot.

Vial

70 mg

BAC Water

2 mL

Dose

3.5 mg

Units on 1 mL

Timing

Frequency

5 days on, 2 days off

Duration

8 weeks on, 8 weeks off

Note: 70mg vial + 2mL BAC water = 35mg/mL. 10 units (0.1mL) = ~2,500mcg GHK-Cu / 500mcg BPC-157 / 500mcg TB-500 per dose.

Also sold as

Research chemical vendors can't legally label products with the real name, so GLOW Blend often appears under coded SKUs. If you're shopping and see any of these, it's the same compound:

GLOW
Glow Stack

Codes shown are for identification only.

Your draw

10 units · 3.5 mg

On a standard 100-unit / 1 mL insulin syringe.

What it actually is

GLOW is a compounded blend of GHK-Cu, BPC-157, and TB-500. GHK-Cu drives copper into fibroblasts to upregulate collagen and elastin; BPC-157 promotes angiogenesis and tissue repair; TB-500 (Thymosin Beta-4 fragment) mobilizes actin to accelerate cell migration into damaged areas. Together they target skin quality, hair, and connective tissue recovery from a single injection.

Most users dose subcutaneously into the abdomen in the morning. Avoid IM near recent fillers or cosmetic work for 7 days.

Why people use it

Visibly firmer, more even skin tone within 4–8 weeks
Faster recovery from cosmetic procedures (microneedling, lasers, PRP)
Hair density and scalp health support
Joint and soft tissue maintenance without juggling three vials

Educational only · Not a vendor claim

How it works

Combines GHK-Cu (collagen/elastin upregulation via copper delivery to fibroblasts), BPC-157 (angiogenesis + soft tissue repair), and TB-500 (actin mobilization for cell migration into damaged tissue) into a single subcutaneous shot.

Health benefits

Firmer, brighter, more even skin tone
Improved hair density and scalp health
Accelerated recovery from microneedling, lasers, PRP
Joint and connective tissue maintenance
Reduced fine lines and improved elasticity

What you'll feel

Visible glow within 3–6 weeks
Faster wound and procedure healing
Less hair shedding
Smoother skin texture

Pros

Three synergistic actives in one injection
Targets skin, hair, and recovery simultaneously
Cost efficient vs. dosing each peptide separately
Clean side effect profile

Cons

Copper from GHK-Cu can tint the solution blue — normal but startling
Not ideal immediately after dermal fillers
Quality depends heavily on compounder

Side effects to know

Mild injection site redness or warmth
Transient flushing from GHK-Cu
Rare lightheadedness early in cycle

Best suited for

Aesthetic recovery and anti agingPost procedure healingHair thinning supportAthletes wanting skin + joint maintenance in one stack

Educational summary · Not medical advice · Discuss with a qualified clinician

What to expect

Typical timeline

General pattern for the Healing category. Individual response varies.

Week 1
Subtle. You may notice slightly less pain or better range of motion. Don't push injuries yet.
Weeks 2–4
Clear improvement in pain and tissue tolerance. Begin controlled loading of the injured area.
Weeks 4–8
Peak repair phase. Function returns. Keep dose consistent — skipping days slows the curve.
Post-cycle
Gains generally stick if you also fixed the underlying mechanics (form, load management, mobility).

Was this page helpful?

The reconstitution math

1Reconstitute the 70 mg vial with 2 mL of bacteriostatic water. Tilt — don't shake.
2Concentration becomes 35,000 mcg/mL (35 mg/mL).
3For a 3.5 mg dose, draw 0.100 mL — that's 10 units on a 1 mL insulin syringe.
4One vial gives you approximately 20 doses.

Reminder: 100 units on an insulin syringe = 1 mL. Always start at half the listed dose for the first week and rotate injection sites between arms, legs, abdomen, and glutes.

Dose log

Dose logging is available for signed-in users. Track today's dose and notes for GLOW Blend.